Banda Research Project team members prepare to excavate a unit in a deep midden mound (Mound 101) at Kuulo Kataa. Orange flagging is tied to grid pegs that have been established across the mound, and white string marks the boundaries of an excavation unit (2W 2S). Team members stand by as Leith Smith (yellow shirt) establishes a unit datum by means of a tight string attached to the master site datum (0W 0N) located nearby. Alex Caton (far right) takes notes. Kuulo Kataa, June, 1995.
Photo of a reconstructed carinate globular pottery jar, with profile depicted (left). The jar was found in an upright position beneath a lens of hardened clay, its rim at 211 cm below datum and its base at 224 cm bd. The jar's mouth is small. Below its lip is a ridge marked with vertical impressions. The surface above the carinated shoulder is decorated with alternating horizontal lines of dentate (comb) impression and grooving. Below the carination, the base and lower portions of the jar are decorated with a carved roulette impression. The interior surface of the jar is heavily eroded, perhaps an indication that the jar was used to store a fermented liquid like millet or sorghum beer. An INAA sample (NA "KK 95-61") from this jar was assigned to the "K1" group of ceramic fabrics. The jar was therefore likely made east of the Banda hills. A jar of similar form, decoration, and interior wear (KK 95-693) was found one meter away and at a slightly lower level in the east profile wall of the excavation unit. Rim diameter: 8 cm. Photo scale in cm. Kuulo Kataa. 13 June, 1995.
Photo of a patially reconstructed carinate globular pottery jar, with profile depicted (left). The jar was partially exposed, sitting upright in the east profile wall of the unit. The jar broke insitu and half of the vessel was removed and reconstructed. The jar has a narrow mouth. Alternating horizontal bands of shallow grooving and dentate (comb) impression decorate the area below the lip. A horizontal grooved line and a line of dentate (comb) impression applied above the carinated shoulder meet at small circular punctate impressions. The base and lower portions of the jar are decorated with a carved roulette impression. The interior surface of the jar is heavily eroded, perhaps an indication that the jar was used to store a fermented liquid like millet or sorghum beer. A jar of similar form, decoration and interior wear was found one meter away and at a slightly higher level in the same unit (KK 95-350). Rim diameter: 10 cm. 50% of vessel reconstructed. Photo scale in cm. Kuulo Kataa. 10 July, 1995.
Photo (interior) of a reconstructed carinate globular pottery jar, with profile depicted (left). The jar was partially exposed, sitting upright in the east profile wall of the unit. The jar broke insitu and half of the vessel was removed and reconstructed. The jar has a narrow mouth. The interior surface of the jar is heavily eroded, perhaps an indication that the jar was used to store a fermented liquid like millet or sorghum beer. A jar of similar form, decoration and interior wear was found one meter away and at a slightly higher level in the same unit (KK 95-350). Rim diameter: 10 cm. 50% of vessel reconstructed. Photo scale in cm. Kuulo Kataa. 10 July, 1995.
Photo of an inward-curving (recurved) jar rim sherd, with profile depicted (left). A zone of diagonally oriented dentate (comb) impressions is bounded on upper and lower edges by a shallow horizontal groove. A mica paint/slip was applied over top of the dentate impressions. The ceramic fabric was tempered with angular quartz grit. An INAA sample ("KK NA-29") was unassigned to a specific group of ceramic fabrics, lending no insight into where the jar was made. Interior neck diameter: 18 cm. Sherd represents an 12% of the jar's circumference. Scale in cm. Kuulo Kataa. 25 June, 1995.